Invacare Mobility Aid 1109379 User Manual

Thumb Saver Wheel Lock  
Assembly, Installation and Operating Instructions  
Kit Noꢀ 1109379  
SAVE THESE INSTRUCTIONS  
NOTE: Check all parts for shipping damageꢀ In case of damage, DO NOT useꢀ Contact Carrier/Invacare  
for further instructionsꢀ  
SAFETY SUMMARY  
To ensure the safe and proper installation of the Thumb Saver Wheel Lock, these instructions  
MUST be followed:  
GENERAL WARNING  
DO NOT install this equipment without first reading and understanding this  
instruction sheet and the owner’s manual provided with the wheelchairꢀ If you  
are unable to understand the warnings, cautions and instructions, contact a  
healthcare professional, dealer or technical personnel if applicable, before  
attempting to install this equipment - otherwise, injury or damage may occurꢀ  
INSTALLATION WARNING  
After ANY adjustments, repair or service and BEFORE use, make sure that all  
attaching hardware is tightened securelyꢀ  
This kit contains the following items:  
Description  
Quantity  
Thumb  
Thumb  
Saver  
Saver  
Wheel  
Wheel  
Wheel Lock Clamp  
2
REPLACING/ADJUSTING THE WHEEL LOCKS (FIGURE 1)  
NOTE: Before adjusting or replacing the wheel locks, ensure that the tires are inflated to the recom-  
mended psi on the sidewall of the tireꢀ  
REPLACING THE WHEEL LOCK  
1$ Loosen the hex screws and remove the existing wheel lock and clamp from the wheelchair$  
2$ Install the new wheel lock clamp onto the wheelchair frame$ Tighten the hex screws securely$  
ADJUSTING THE WHEEL LOCK  
1$ Engage the wheel locks$  
NOTE: Any wheel lock adjustment should embed the wheel lock shoe at least 3/16-inch into the pneu-  
matic tire (1/8-inch for urethane wheels) when engagedꢀ  
2$ If necessary, loosen the hex screw(s) that secure the wheel locks to the wheelchair frame  
and adjust the position of the wheel lock until the 3/16-inch (1/8-inch for urethane wheels)  
measurement is obtained for correct wheel lock adjustment$  
3$ Securely tighten the hex screw(s)$  
4$ Engage the wheel locks and push against the wheelchair and determine if the wheel locks  
engage the wheel enough to hold the wheelchair$  
5$ Repeat the above procedures until the wheel locks hold the wheelchair$  
1
 

Intel Computer Hardware Raptor AT User Manual
Intellinet Network Solutions Welding Consumables 521796 User Manual
JBL Music Mixer ND310II User Manual
JBL Stereo Amplifier S7150 User Manual
John Lewis Beverage Dispenser JLWFF1552 User Manual
JVC Automobile Battery Charger XV N327B User Manual
JVC CD Player KS FX480R User Manual
JVC Universal Remote RM RK60P User Manual
Kenmore Microwave Oven 72180402 User Manual
Kodak Camcorder Ze2 User Manual