Jasco TV Converter Box AV93299 User Manual

AV93299  
Video Converter  
(RF Modulator)  
INSTRUCTION MANUAL  
Please read before using this equipment.  
 
NOTETO CATV SYSTEM INSTALLER:  
INTRODUCTION  
This reminder is provided to call the CATV system installers  
attention to Article 820-40 of the NEC that provides guidelines for  
proper grounding and, in particular, specifies that the cable  
ground shall be connected to the grounding system of the build-  
ing, as close to the point of cable entry as practical.  
Your Video Converter (RF Modulator) is designed to convert  
the separate audio and video signals (from a DVD, video  
camera, or video game, for example) into VHF TV signals  
that you can view on aTV set equipped with only a 75 Ohm  
(F-type) input.  
WARNING:To prevent fire or shock hazard, do not expose this  
product to rain or moisture.This unit for indoor use only  
The FCC WantsYou to Know  
This device complies with Part 15 of FCC Rules. Operation is  
subject to the following two conditions: (1)This device may  
not cause harmful interference, and (2) this device must  
accept any interference received, including interference that  
may cause undesired operation.  
CAUTION  
RISK OF ELECTRIC SHOCK.  
!
DO NOT OPEN  
CAUTION:TO REDUCETHE RISK OF ELECTRIC SHOCK,  
DO NOT REMOVE COVER OR BACK. NO USER-  
SERVICE-ABLE PARTS INSIDE. REFER SERVICING  
TO QUALIFIED PERSONNEL.  
Your modulator might causeTV or radio interference even  
when is operating properly.To determine whether your mod-  
ulator is causing the interference, turn it off. If the interfer-  
ence goes away, your modulator is causing it.  
The lightning flash with arrowhead symbol, within an  
equilateral triangle, is intended to alert the user to the  
presence of uninsulated “dangerous voltage” within  
the products enclosure that may be of sufficient mag-  
nitude to constitute a risk of electric shock to persons.  
Try to eliminate the interference by:  
moving your RF Modulator away from the receiver  
connecting your RF Modulator to an outlet that is on a  
different electrical circuit from the receiver  
contacting your lcoal store for help  
The exclamation point with an equilateral triangle is  
intended to alert the user to the presence of important  
operating and maintenance (servicing) instructions in  
If you cannot eliminate the interference, the FCC requires  
that you stop using your RF Modulator. Changes or modifi-  
cations not expressly approved by the party responsible for  
compliance could void the users FCC authorization to oper-  
ate this equipment.  
!
the literature accompanying the appliance.  
Notice :The changes or modifications not expressly approved by  
the party responsible for compliance could void the user‘s  
authority to operate the equipment.  
2
3
 
REQUIRED PARTS  
The following items (not supplied) are required to connect  
your RF Modulator to a video input source and yourTV.  
CONNECTIONS  
Follow these steps to connect your RF Modulator.  
1. If your video source is stereo, plug the connectors on  
one end of a stereo A/V cable into the video and audio  
input jacks on the RF Modulator. Plug the connectors  
on the cables other end into to video and audio output  
jacks on the video source, using the color coding on  
one audio/video shielded cable with three phono  
connectors at each end, if the video sources audio  
output is stereo; or one audio/video shielded cable  
with two phono connectors at each end if the video  
sources audio output is monaural  
two 75-ohm coaxial cables with F-type connectors  
a 75-ohm-to-300-ohm matching transformer, if yourTV  
does not have a VHF 75-ohm F-connector  
the connectors as a guide.  
Video Source  
(DVD Player)  
Note:The audio signal will be modulated to mono,  
whether the video source is stereo or monaural.  
If your video source is monaural, plug the connectors on  
one end of an A/V cable into the video and audio input  
jacks on the RF Modulator (using the AUDIO L jack). Plug  
the cables other ends into the video and audio jacks on  
the video source. Connect the 75-ohm coaxial cables to  
the RF Modulator following these guidelines:  
Video Source  
(DVD Player)  
Note to the CATV System Installer:This reminder is  
provided to call the CATV system installers attention to  
article 820-22 of the NEC that provides guidelines for  
proper grounding and, in particular, specifies that the  
cable ground shall be connected to the grounding system  
of the building, as close to the point of cable entry as  
practical.  
4
5
 
If yourTV is already connected to another VHF input  
source (such as cable, an antenna, or a VCR, for  
example), disconnect the VHF input sources 75-ohm  
cable from theTVs 75-ohme VHF/UHF terminal, and  
reconnect it to the RF Modulators ANT IN terminal.  
Then connect a 75-ohm coaxial cable between theTO  
TV terminal on the RF Modulator and the 75-ohm  
VHF/UHF terminal on yourTV.  
Note: If yourTV has only 300-ohm VHF screw terminals,  
use a 75-ohm-to-300-ohm matching transformer to  
complete the connection.  
2. Plug the RF Modulators power cord into a standard AC  
outlet.  
If yourTV is not already connected to another VHF  
source, connect a 75-ohm coaxial cable between to the  
TOTV terminal on the RF modulator and the75-ohm  
VHF/UHF terminal on yourTV.  
OPERATION  
1. Turn on theTV and set it to either Channel 3 or 4.  
whichever is not used for regular broadcasts in your  
area.  
6
7
 
2. Set the RF Modulators CHANNEL 3/4 switch to the  
same channel you set theTV (3 or 4).  
SPECIFICATIONS  
3.Turn on the connected video source and set OHMS  
75/1K on the RF Modulator to the position that gives  
the best picture.The video signal indicator on the RF  
Modulator lights when the modulator is receiving a  
signal for an A/V source.  
Video Carrier Output Level . . . . . . . . . . . . . . . . . . . . . . . .69dB_V  
RF Output Channels . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 or 4  
RF Output Impedance . . . . . . . . . . . . . . . . . . . . . . . . . . .75 Ohms  
Video Input Impedance . . . . . . . . . . . . . . . . . .75 Ohms/1K Ohms  
(Switchable)  
Audio Input Impedance . . . . . . . . . . . . . . . . . . . . . . .13_3K Ohms  
TV to ANT Insertion Loss 50 - 806 MHz . . . . . . . . . . . . . . . . .-2dB  
Dimensions . . . . . . . . . . . . . . . . . . .513/16 x 31/16 x 17/16 inches  
(148 x 78 x 37 mm)  
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 lb 2.5 oz  
.524 kg  
CARE  
To enjoy your RF Modulator for a long time:  
• Keep the modulator dry. If it gets wet, wipe it dry  
immediately.  
Specifications are typical; individual units might vary.  
Specifications are subject to change and improvement  
without notice.  
• Use and store the modulator only in normal temperature  
environments.  
• Handle the modulator gently and carefully. Don’t drop it.  
• Keep the modulator away from dust and dirt.  
Wipe the modulator with a damp cloth occasionally to  
keep it looking new.  
Modifying or tampering with the modulators internal  
components can cause a malfunction and invalidate its  
warranty and void your FCC authorization to operate it. If  
your modulator is not performing as it should, take it to  
your local store for assistance.  
8
9
 
FCC Compliance Statement  
90 DAY LIMITED WARRANTY: Jasco Products Co.,  
Inc. warrants this product to be free from manufactur-  
ing defects for a period of ninety days from the origi-  
nal date of consumer purchase. This warranty is limit-  
ed to the repair or replacement of this product only  
and does not extend to consequential or incidental  
damage to other products that may be used with this  
unit. This warranty is in lieu of all other warranties  
express or implied. Some states do not allow limita-  
tions on how long an implied warranty lasts or permit  
the exclusion or limitation of incidental or consequen-  
tial damages, so the above limitations may not apply  
to you. This warranty gives you specific rights, and  
you may also have other rights which vary from state  
to state. If unit should prove defective within the  
warranty period, return prepaid with dated proof of  
purchase to: Jasco Products Co., Inc., 311 N.W.  
122nd, Oklahoma City, OK. 73114  
This equipment has been tested and found to comply  
with the limits for a Class B digital device, pursuant  
to Part 15 of the FCC Rules.These limits are designed  
to provide reasonable protection against harmful  
interference in a residential installation.This equip-  
ment generates, uses and can radiate radio frequency  
energy and, if not installed or used in accordance  
with the instructions, may cause harmful interference  
to radio communications. However, there is no guar-  
antee that interference will not occur in television  
reception, which can be determined by turning the  
equipment off and on, the user is encouraged to try  
and correct the interference by one or more of the  
following measures:  
(1) Reorient or relocate the receiving antenna.  
(2) Increase the separation between the equipment  
and the receiver.  
(3) Connect the equipment into an outlet on a circuit  
different from that to which the receiver is  
connected.  
(4) Consult the dealer or an experienced radio/TV  
technician for help.  
GARANTIA LIMITADA DE NOVENTA: Jasco Products., Co. Inc.  
garantiza este producto por un periodo de noventa días desde la  
fecha de la compra original, como libre de defectos de fabricación.  
Esta garantía está limitada a la reparación o reemplazo de este pro-  
ducto y no se extiende a daños consecuentes o incidentales en otros  
productos que puedan ser usados con esta unidad. Esta garantía es  
en vez de cualquier otra expresa o implícita. Algunos estados no  
permite limitacíones al tiempo de limitada o permite el exclusión o  
limitaciones del daños incidental o consiguiente, así el limitacíon  
del arriba no aplicarse. Esta limitada darse justicia, y talvez tiene  
otro justicias que cambia del estado a estado. Si la unidad resulta  
defectuosa durante el periodo de garantía, devolverla prepagada a:  
Jasco Products Co., Inc., 311 N.W. 122nd. Street, Oklahoma  
City, OK. 73114  
FCC WARNING:  
Changes or modifications not expressly approved by  
the party responsible for compliance could void the  
users authority to operate the equipment.  
10  
11  
 
Distributed for Thomson Consumer Electronics, Inc.  
by Jasco Products, Co., Inc.,  
311 N.W. 122nd Street,  
Oklahoma City, Oklahoma 73114  
 

InFocus Cordless Drill DS 12DM User Manual
Inglis Home Appliances Microwave Oven IOR14XR User Manual
JBL Speaker SR4733X User Manual
Jonsered Brush Cutter BC2043 User Manual
JVC CD Player KD LH910 User Manual
Kaidan Camera Accessories QuickPan Panoramic Tripod Head User Manual
Kettler Patio Furniture 01638 000 User Manual
KitchenAid Blender 4KFP720BU2 User Manual
KitchenAid Clothes Dryer KEYE750V User Manual
KitchenAid Toaster 4KPTT780 User Manual