Invacare Mobility Aid 1048085 User Manual

Quad Cane Camlock Replacement Kit  
Assembly, Installation and Operating Instructions  
Model Nos. 1055948  
SAVE THESE INSTRUCTIONS  
NOTE: Check ALL parts for shipping damage. In case of shipping damage, DO NOT use. Contact  
Carrier/Dealer for further instructions.  
Safety Summary  
To ensure the safe and proper installation of the Quad Cane Camlock, these instructions  
Must be followed:  
WARNING  
DO NOT use this equipment without first reading and understanding this instruction  
sheet. If you are unable to understand the warnings, cautions and instructions, contact  
a healthcare professional, dealer or technical personnel if applicable, before  
attempting to install this equipment - otherwise, injury or damage may occur.  
Invacare products are specifically designed and manufactured for use in conjunction  
with Invacare accessories. Accessories designed by other manufacturers have not  
been tested by Invacare and are not recommended for use with Invacare products.  
Camlock MUST be properly engaged (locked) during use.  
Double-button MUST be fully engaged and protruding through height adjustment  
hole on cane handle to ensure a positive lock.  
ALWAYS test to see that the cane handle is properly and securely locked in place  
before using. This will ensure that camlock is secure.  
Quad Canes are designed to provide ambulatory assistance to an individual weigh-  
ing up to 250 lbs. (113.6 kg.). The replacement camlock does not in any way change  
the weight limitation of your quad cane.  
Description of Kit  
ITEM  
1048085  
DESCRIPTION  
Cam Lever  
QTY  
1
1048086  
Cam Housing  
1
Assembling the Camlock  
NOTE: For this procedure, refer to Detail “A” of FIGURE 1 on page 2.  
1. Soak camlock housing in warm water for approximately 10 minutes.  
NOTE: Soaking will allow the housing to soften adequately to aid in installation.  
2. Remove housing from water.  
3. Insert cam lever into camlock housing, handle first, through cutout in camlock housing.  
4. Rotate cam lever 90° until the rear (round) portion of the cam lever is positioned into  
the recess of the cam housing with large tab on rear of cam lever facing down.  
For more information regarding Invacare products, parts, and services,  
Part No 1055947  
1
Quad Cane Camlock Replacement Kit  
 

Ingersoll Rand Heat Pump TP10445SXXXXXXXX User Manual
Intellinet Network Solutions Network Router 525312 User Manual
Intellinet Network Solutions Switch 524117 User Manual
John Deere Compact Loader 160G LC User Manual
JVC Flat Panel Television 0709TMH II IM User Manual
JVC Portable CD Player RC BZ5LB User Manual
Kambrook Slow Cooker KSC 100 User Manual
Kathrein Satellite TV System UFD 430 User Manual
Kenmore Microwave Oven 72162362 User Manual
Kicker Stereo Amplifier ZX5503 User Manual